We have many kinds of ballasted solar mounting structure with steel or aluminum material. This article is going to introduce one with special function, which have the adjustable angles and directions. The front view of this type solar mounting as following.

This type mounting consists of only seven parts, which is Pre-assembled Mounting, Foundation, Rail, Inter and End Clamps, Base foot for Mounting and Plastic wing nut. It’s very easy to install it. Let’s see.

Step1. Fixed the foundation

Step2. Install the base foot on the foundation beam.

Step3. Install the pre-assembly mounting on the foundation beam Including of front and rear base feet.

Then this part is done and overview as following,

Step4. Repeat same installation on the another side and keep the top, bottom, left and right sides aligned, then tighten all the screws

Step5. Place the rail on the sloping beam of the pre-assembled mounting, then fix it with the plastic wing nut. (NOTE: the screw is pre-locked first)

Step6. Repeat same installation for another rails. Both ends of the rail should stay aligned. Tighten all the screws after the rail is adjusted in right position

Step7. Install solar panels with inter and middle clamps

If you want to adjust the angles, please move the rear base foot back to the where you want  (the plastic wing nut as a slider). But limit angle is 10°, where below pictures shown. And the other parts don't move.

If you want to change direction manually, please dismantle the base footand re-install into another direction. No need to move foundation beam.

De hele installatie is gedaan.